What aspects should be paid special attention to in a single-cylinder cone mobile crushing station?

When solving common problems of a mobile single-cylinder cone crushing station, special attention should be paid to the following aspects:

1. Equipment startup and operation inspection

Electrical and oil circuit inspection

Before starting, it is necessary to confirm that the electrical circuit and the oil pump motor starter are normal to avoid the equipment from failing to start due to circuit failure.

Check the lubricating oil level, oil quality and oil pipe sealing to prevent equipment damage due to insufficient oil or oil circuit leakage.

Clean the oil filter element regularly to prevent blockage from affecting oil pressure and oil flow.

Equipment operation monitoring

During operation, close attention should be paid to parameters such as oil temperature, oil pressure, and current to ensure that they are within the normal range.

Pay attention to whether the equipment has abnormal sounds, vibrations or high temperatures, and promptly discover and handle potential faults.

2. Fault handling and maintenance

Targeted fault resolution

Oil temperature is too high: Check whether the cooling system is working properly, clean the cooler, and ensure sufficient cooling water supply.

Abnormal oil pressure: Check whether the oil pipe and oil groove are blocked, whether the safety valve fails, and clean or replace the faulty parts in time.

Equipment vibration: Tighten the loose bolts, check whether there are difficult-to-crush materials or blockages in the crushing chamber, and clean and adjust the feed amount in time.

Abnormal noise problem: Check whether the gear is installed correctly, whether the middle friction ring is worn, and adjust the gap or replace the worn parts in time.

Regular maintenance and care

Regularly replace lubricating oil and wearing parts (such as linings, bearings, etc.) to ensure that the equipment is in good operating condition.

Check and adjust the size of the discharge port to ensure that the product particle size meets the requirements.

Clean the residue inside and outside the equipment to prevent the accumulation of materials from affecting the * of the equipment.

3. Safe operation and protection

Operation specifications

Operators must undergo * training and be familiar with the * and operating procedures of the equipment.

It is strictly forbidden to touch the rotating parts or move the protective cover during operation to prevent safety accidents.

When repairing or inspecting the equipment, it must be carried out after the equipment s*s steadily and the power supply is cut off.

Protective measures

Install an iron removal device at the feed inlet to prevent non-crushed materials from entering the crushing chamber and damaging the equipment.

Equip with necessary protective equipment (such as safety helmets, goggles, etc.) to ensure the safety of operators.