0086-371-67660555 Email:sales@zxcrusher.com
cone crusher nerws banner

position: Home > News > Cone crusher spout how to adjust the proper use

Cone crusher spout how to adjust the proper use

Time:2015-08-17 02:41:36 10:10:46 AM Num:84

Material towards the discharge port is finished the last hurdle, the size of the particle size of the material feed rate needs to adjust it, but cone crusher discharge port will move in the course of work and the cone cone lining lining continues wear becomes large, which is obviously not conducive to the quality of the product. In order to ensure uniformity of product size, we need to spout sizes varying degrees of adjustment.


To adjust the cone machine spout size, generally require the use of the adjustment ring, reducing fixed cone liner, supporting suite of serrated thread lift adjustment can be achieved. After the break the cone adjusted discharge port, you can use wire-based approach to measure the size of shot size, and then adjust the locking cylinder locking ring after a good start, go to safe production.


coner crusher1 


Production cone crusher discharge inequality is also not just because of the problems resulting from the discharge port, generally consists of three causes, for the reasons given in Jiaozuo Zhongxin Heavy three suggestions:
A correct feed
1, clear the parameters used cone crusher, especially the nature of materials requirements, according to the crusher to the material requirements, put suitable material. For example, the temperature is too high or too much water, you can make the appropriate processing, so that the material as much as possible at or near requirement to avoid the crushed material is not standard size.


2, feeding machine too easily lead to uneven load operation, the expected product size uniform, moving cone, fast fixed cone liner wear, which seriously affected the production capacity of the equipment. For this case, through the transformation of the ore hopper, so to mine even unloading in the distribution disk, thereby uniformly fed into the crushing chamber, solving the uneven particle size, the machine overloaded and so on.


Second, the equipment maintenance
Dynamic cone crusher is the main part of the
cone crusher, moving cone subject to wear will seriously reduce the crushing effect of the material. Therefore, production should be careful to check the use of the moving cone, cone moving parts to reduce wear. As dynamic cone and fixed cone Face laced with manganese steel liner to protect the cone from wear and tear, ensure that the material in the crushing effects of the crushing cavity.


Third, the timely adjustment of parameters


1, when the material into a cone crusher in the changes to the timely adjustment nesting population size based on the nature of broken material. After the adjusted discharge port, you can use wire-based approach to measure the size of shot size, when the discharge port after the adjustment been to reach the user's needs, you should first adjust the ring with a locking cylinder lock Restart the device, and then enter the safe production.


2, in the production site should be careful to check the adequacy of the operating voltage, the tightness of the belt is moderate, if irregularities shall timely adjustments provide sufficient power conditions for normal crushing cone crusher crushing materials in order to avoid uneven size.
Understanding these discharge cone crusher of knowledge of future production would be helpful, users can according to their actual needs to adjust freely, so conducive to the production, operation more convenient and simple. Of course, there are other complex issues can call us in Zhongxin Heavy 24-hour hotline.

Search


Contact us